Subject	Damn...
Posted by	-Grimm- on August 13, 2013 at 11:56 PM
	This message has been viewed 239 times.
In Reply To	Re: Even more information posted by rhombicblue on August 10, 2013 at 07:25 PM
Message	Just ran a compression test. Had to do it with a jump pack so my car was only spinning ~150 rpm but... Should be 125 minimum 1/ 65 2/ 32 3/ 58 4/ 89 5/ 62 6/ 70 Woah buddy that's terrible. Put oil in a couple of the cylinders and it got worse (which makes no sense to me). So I'm under the impression it's either a cracked block or head problem (cracked or valves). Still, wouldn't it at least try to start?
Follow Ups	1990 TTZ Won't Fire - -Grimm- 08:08:45 08/09/13 A little more info... - -Grimm- 08:13:04 08/09/13 If you have spark, fuel and air, it should start. I would - CmyZ 09:12:35 08/09/13 I will see if I can borrow an ECU. - -Grimm- 10:38:35 08/09/13 What possible causes would make the ECU to go bad? - -Grimm- 10:49:44 08/09/13 Re: 1990 TTZ Won't Fire - rhombicblue 17:59:15 08/09/13 I just replace the head gaskets - -Grimm- 18:58:02 08/09/13 its turning over or u just hear the starter spinning? (n/m) - 300ZMang 19:14:22 08/11/13 It's cranking, I can see the fan spinning - -Grimm- 20:35:03 08/11/13 I tested the PTU with a multimeter per the FSM - -Grimm- 16:03:24 08/12/13 Even more information - -Grimm- 01:39:11 08/10/13 Re: Even more information - rhombicblue 19:25:44 08/10/13 Damn... - -Grimm- 23:56:18 08/13/13 try another compression tester to double check - dvice 02:59:29 08/14/13 could also try leakdown (n/m) - dvice 03:07:33 08/14/13 I was considering running a leak down test... - -Grimm- 12:27:00 08/14/13 Re: Damn... - rhombicblue 13:48:25 08/14/13
Post a Followup	You cannot reply to this message because you are not logged in.