Subject	Something is bent
Posted by	Cjw3 on August 05, 2013 at 6:53 AM
	This message has been viewed 193 times.
In Reply To	Timing Belt Rubbing posted by tomas1329 on August 05, 2013 at 12:23 AM
Message	Either the Tensioner assembly has Krap behind it, and is bolted crooked, or you have a bent/Bad Idler Assembly.. OBVIOUSLY do not drive it for fear of sudden death.. Think you will miss the alignment today.. Get a new Timing set WITH STUDS and try again.. Cj
Follow Ups	Timing Belt Rubbing - tomas1329 00:23:00 08/05/13 Something is bent - Cjw3 06:53:04 08/05/13 Re: Something is bent - tomas1329 07:54:14 08/05/13 Loose the belt will wander - Cjw3 10:31:01 08/05/13 I can also remember something about a curved washer - Medallion Man 08:44:36 08/05/13 this might be of help... - Medallion Man 08:58:24 08/05/13 Usually this is caused by the big round washer/plate that - Krazyd27(Houston) 11:46:12 08/05/13 Just went through the same issue... - baggar11 17:00:44 08/05/13 Washer(s) behind tensioner. - 90GoldZ 03:45:35 08/06/13
Post a Followup	You cannot reply to this message because you are not logged in.