Subject	Elbow is press fit (use some pliers and twist it)
Posted by	-Grimm- on July 29, 2013 at 3:12 PM
	This message has been viewed 196 times.
In Reply To	Remove 90 degree elbow, install elbow onto hose. posted by 90GoldZ on July 27, 2013 at 07:26 PM
Message	Or you could just delete the rear exhaust PCV lines with a 3/8" NPT plug. Already has the PCV lines from both intake valve covers... Use a 1/4" NPT plug for the manifold side. Drill tap both out first, don't overtighten or you risk cracking the cast manifold. [ http://z32.wikispaces.com/PCV+Delete ]
Follow Ups	installing driverside, rear PCV silicone hose; need help... - David G 19:06:24 07/27/13 Remove 90 degree elbow, install elbow onto hose. - 90GoldZ 19:26:19 07/27/13 Thanks. Does elbow twist off and tap back in? (n/m) - David G 13:06:24 07/28/13 pry it off and use some gasket sealer before reinserting - CmyZ 13:17:04 07/28/13 Elbow is press fit (use some pliers and twist it) - -Grimm- 15:12:41 07/29/13
Post a Followup	You cannot reply to this message because you are not logged in.