Subject	Small (10mm) Head Bolts
Posted by	-Grimm- on July 29, 2013 at 2:00 PM
	This message has been viewed 365 times.
Message	Is there any reason to put these bolts back on? They're small enough to not have any effect on sealing. I'm thinking they were put on at the factory to keep the head from falling off during transit between stages of assembly. I left them out to allow me to skip a few steps when I take the motor apart in the future (being able to leave the timing gears and backplate on the DS) Thanks
Follow Ups	Small (10mm) Head Bolts - -Grimm- 14:00:30 07/29/13 Re: Small (10mm) Head Bolts - aliaZ 17:06:30 07/29/13 Helps keep them from dropping on your foot - ThisIsSparTTa 11:36:33 07/30/13 That sounds a little sketchy. - Krazyd27(Houston) 17:22:26 07/30/13 Re: That sounds a little sketchy. - -Grimm- 11:02:39 07/31/13
Post a Followup	You cannot reply to this message because you are not logged in.