Subject	You're not snapping the bit because it's weak
Posted by	BlackholeZ on July 28, 2013 at 3:15 PM
	This message has been viewed 206 times.
In Reply To	Stubborn bolt posted by rojoloco (VA Beach) on July 27, 2013 at 07:36 PM
Message	The hardest part is keeping the bit straight and square to the hole. The hard thing about trying to drill out the broken drill is that the broken piece will also spin instead of being cut. Sometimes you can pull the broken piece out with a strong magnet. There are also sockets that you pound on to the rounded bolt to try and get it out. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Stubborn bolt - rojoloco (VA Beach) 19:36:42 07/27/13 Did you try a tungsten carbide bit yet? - Evan_Wright (Ca) 19:52:58 07/27/13 Not sure. - rojoloco (VA Beach) 21:10:10 07/27/13 High Speed Steel, I'd imagine. Good for wood, not much else (n/m) - jkperformance 21:22:33 07/27/13 Kobalt is better than HSS, but not as hard as carbide. - zellamay 08:15:47 07/28/13 Kobalt is a brand. cobalt is what you were thinking, prob (n/m) - jkperformance 16:09:38 07/28/13 Yes, I was thinking matl, not brand. - zellamay 17:34:18 07/28/13 You're not snapping the bit because it's weak - BlackholeZ 15:15:31 07/28/13 It's definitely proving to be a challenge. - rojoloco (VA Beach) 21:23:46 07/28/13 A picture really might spark someone's imagination. (n/m) - zellamay 01:42:52 07/30/13 Is there enough room for vise-grips? (n/m) - -Grimm- 14:40:23 07/29/13 Drill-Out extractor, bit built-in, reverse threaded - Ron(Houston) 21:46:16 07/31/13
Post a Followup	You cannot reply to this message because you are not logged in.