Subject	Porting...????
Posted by	Z ONLY1 on July 10, 2013 at 4:01 PM
	This message has been viewed 161 times.
Message	Well since the heads are the only parts I have not upgraded or rebuilt...there is my winter project. Took heads off another engine I have to get started, presently Z running...OK, needs more, heads are limiting me. I am by no means a machinist...but understand porting and objectives....so...I thought I would do little improvements from plenum/lower plenum/heads/MS manifolds. For those who have done this...is it necessary to have the heads thoroughly cleaned before any porting? I would think I could smooth & little grinding before they are cleaned? Thanks for any input/opinions.
Follow Ups	Porting...???? - Z ONLY1 16:01:48 07/10/13 A couple of thoughts: No reason to clean before porting. - zellamay 16:49:47 07/10/13 More smoothing than extreme porting.... - Z ONLY1 17:54:15 07/10/13
Post a Followup	You cannot reply to this message because you are not logged in.