Subject	Re: Stock fork and pivot ball?
Posted by	tt_703 on July 10, 2013 at 11:21 AM
	This message has been viewed 192 times.
In Reply To	Stock fork and pivot ball? posted by Woody75 (Denver) on July 10, 2013 at 10:55 AM
Message	Upgraded folk and pivot ball from Z1, stock throwout bearing, when the tranny is install, there little to almost no play in the fork. When the tranny is apart, the fork will move along the the TO very smoothly, no problem.
Follow Ups	clutch installed, unable to step on paddle ? - tt_703 21:50:07 07/09/13 um... that's not the proper order for installation - jkperformance 22:31:52 07/09/13 Corrected myself - of couse I did not install the clutch - tt_703 22:40:22 07/09/13 with the trans out, can you manually operate the fork and - jkperformance 22:52:30 07/09/13 Re: with the trans out, can you manually operate the fork and - tt_703 05:51:23 07/10/13 Stock fork and pivot ball? - Woody75 (Denver) 10:55:31 07/10/13 Re: Stock fork and pivot ball? - tt_703 11:21:15 07/10/13 Was the pivot ball shorter than the old one you removed? (n/m) - Woody75 (Denver) 13:36:49 07/10/13 unsure of that, again everthing worked fine a few month back (n/m) - tt_703 14:09:09 07/10/13 Oh, so the fork and ball were al ready in use? - Woody75 (Denver) 14:55:06 07/10/13 updated: just checked, yup the pivot ball on the trans is - tt_703 21:17:37 07/10/13 Is there any play when the slave is installed? - Woody75 (Denver) 22:16:27 07/10/13
Post a Followup	You cannot reply to this message because you are not logged in.