Subject	Took it to the machine shop, he used a vacuum tester on it
Posted by	ttsmokin on July 04, 2013 at 10:41 PM
	This message has been viewed 271 times.
In Reply To	try putting the cams back in and recheck leak down posted by aliaZ on July 04, 2013 at 10:13 AM
Message	The two exhaust valves on cyl 6 are not sealing at all, they appear to be bent when spun in his lathe. He said he will look into it more tomorrow and let me know. I pulled the cylinder head off the other side, it looks so much cleaner, less carbon. Perhaps I have tapered or out of round bores that pass oil through and that is why the piston rings worn a little off. Might be time to do a full rebuild, I hate to do the head work and leave a bottom end that might not be 100%.
Follow Ups	Low compression diagnosis - ttsmokin 21:22:17 07/02/13 seems like a valve problem to me - aliaZ 22:07:52 07/02/13 Time for another valve job I guess - ttsmokin 23:03:13 07/02/13 not concerned with the wear pattern or bearing wear (n/m) - aliaZ 10:11:19 07/04/13 I did a leak down test today - ttsmokin 23:25:13 07/03/13 try putting the cams back in and recheck leak down - aliaZ 10:13:04 07/04/13 Took it to the machine shop, he used a vacuum tester on it - ttsmokin 22:41:52 07/04/13 your bores look worn - aliaZ 23:02:37 07/04/13
Post a Followup	You cannot reply to this message because you are not logged in.