Subject	try putting the cams back in and recheck leak down
Posted by	aliaZ on July 04, 2013 at 10:13 AM
	This message has been viewed 226 times.
In Reply To	I did a leak down test today posted by ttsmokin on July 03, 2013 at 11:25 PM
Message	If the valve stem height is wrong, the lifters will bottom out and hold your valve open slightly
Follow Ups	Low compression diagnosis - ttsmokin 21:22:17 07/02/13 seems like a valve problem to me - aliaZ 22:07:52 07/02/13 Time for another valve job I guess - ttsmokin 23:03:13 07/02/13 not concerned with the wear pattern or bearing wear (n/m) - aliaZ 10:11:19 07/04/13 I did a leak down test today - ttsmokin 23:25:13 07/03/13 try putting the cams back in and recheck leak down - aliaZ 10:13:04 07/04/13 Took it to the machine shop, he used a vacuum tester on it - ttsmokin 22:41:52 07/04/13 your bores look worn - aliaZ 23:02:37 07/04/13
Post a Followup	You cannot reply to this message because you are not logged in.