Subject	Time for another valve job I guess
Posted by	ttsmokin on July 02, 2013 at 11:03 PM
	This message has been viewed 229 times.
In Reply To	seems like a valve problem to me posted by aliaZ on July 02, 2013 at 10:07 PM
Message	Does the 2nd ring wear pattern concern you or the bearing wear? Upon doing some research, some 2nd piston rings may use a taper design which would explain the top side not being worn as much. Makes sense if we have tapered scraper rings?
Follow Ups	Low compression diagnosis - ttsmokin 21:22:17 07/02/13 seems like a valve problem to me - aliaZ 22:07:52 07/02/13 Time for another valve job I guess - ttsmokin 23:03:13 07/02/13 not concerned with the wear pattern or bearing wear (n/m) - aliaZ 10:11:19 07/04/13 I did a leak down test today - ttsmokin 23:25:13 07/03/13 try putting the cams back in and recheck leak down - aliaZ 10:13:04 07/04/13 Took it to the machine shop, he used a vacuum tester on it - ttsmokin 22:41:52 07/04/13 your bores look worn - aliaZ 23:02:37 07/04/13
Post a Followup	You cannot reply to this message because you are not logged in.