Subject	seems like a valve problem to me
Posted by	aliaZ on July 02, 2013 at 10:07 PM
	This message has been viewed 231 times.
In Reply To	Low compression diagnosis posted by ttsmokin on July 02, 2013 at 09:22 PM
Message	there shouldn't be any bubbles if the valve job was done right
Follow Ups	Low compression diagnosis - ttsmokin 21:22:17 07/02/13 seems like a valve problem to me - aliaZ 22:07:52 07/02/13 Time for another valve job I guess - ttsmokin 23:03:13 07/02/13 not concerned with the wear pattern or bearing wear (n/m) - aliaZ 10:11:19 07/04/13 I did a leak down test today - ttsmokin 23:25:13 07/03/13 try putting the cams back in and recheck leak down - aliaZ 10:13:04 07/04/13 Took it to the machine shop, he used a vacuum tester on it - ttsmokin 22:41:52 07/04/13 your bores look worn - aliaZ 23:02:37 07/04/13
Post a Followup	You cannot reply to this message because you are not logged in.