Subject	Turbo Housings - Simple to separate?
Posted by	evan_aggie on June 27, 2013 at 3:57 PM
	This message has been viewed 154 times.
Message	I was just wanting to check if folks knew whether removing the compressor side snap-ring and the 5 bolts on the exhaust housing were enough to separate them from the CHRA? I did this just to reclock the housings, but I didn't actually check to see if they would pop off. I wanted to take some apart to get them cleaned and likely coated with a ceramic or other type of treatment.
Follow Ups	Turbo Housings - Simple to separate? - evan_aggie 15:57:04 06/27/13 Yep. - Woody75 (Denver) 16:39:50 06/27/13 Re: Turbo Housings - Simple to separate? - GCamp 10:55:58 07/02/13
Post a Followup	You cannot reply to this message because you are not logged in.