Subject	^this. I fought a random misfire for a while
Posted by	Lumpydonut on June 18, 2013 at 2:17 PM
	This message has been viewed 269 times.
In Reply To	Sounds like a connector issue, I'd check maf/temp sensor. (n/m) posted by TriniTT on June 18, 2013 at 01:20 PM
Message	turns out it was cylinder 3 injector connector. Would get hot and bend too much, cut out for a while until I poked the wire. Run fine until it got stupid hot again. Cut, solder, replace, no issues since.
Follow Ups	Misfire, stuttering issues - Carlos Ramirez 09:14:37 06/18/13 Vacuum/boost leaks? Can you explain your misfire in greater - TriniTT 09:17:31 06/18/13 Misfire all the time or under certain conditions? - TTZ2NV(EPTmotorsports) 10:09:42 06/18/13 Re: Misfire, stuttering issues - Carlos Ramirez 10:29:55 06/18/13 Injector? (n/m) - ChaseGrayTT 10:51:41 06/18/13 maybe? But they ohmd out correctly (n/m) - Carlos Ramirez 11:04:07 06/18/13 Could be clogged. - ChaseGrayTT 13:45:54 06/18/13 Which plugs and how many miles on them? (n/m) - MixManMash 10:49:02 06/18/13 had NGK BKR7eix in there put some ZFR7f-11 in for now - Carlos Ramirez 11:05:42 06/18/13 gap and boost level ? (n/m) - ZWolf 11:22:37 06/18/13 I'd swap in and test with a known good CAS if you haven't .. (n/m) - SniPer (SR-71) 12:06:30 06/18/13 don't have one :-) I have thought of that - Carlos Ramirez 12:23:09 06/18/13 CAS connector clean & seated correctly? (n/m) - vorpalZ 15:44:14 06/18/13 Sounds like a connector issue, I'd check maf/temp sensor. (n/m) - TriniTT 13:20:10 06/18/13 ^this. I fought a random misfire for a while - Lumpydonut 14:17:39 06/18/13 these are all helpful hints - 300ZMang 18:52:47 06/18/13 update - Carlos Ramirez 21:34:19 06/18/13 I have a few spare parts I can let you borrow - 90GoldZ 00:50:08 06/19/13 thank you sent an email (n/m) - Carlos Ramirez 14:25:24 06/19/13 updated 6-20 - Carlos Ramirez 20:14:34 06/20/13
Post a Followup	You cannot reply to this message because you are not logged in.