Subject	Sport500 pre-install questions
Posted by	bartz32tt on June 18, 2013 at 10:35 AM
	This message has been viewed 399 times.
Message	1. Both of my wastegates have a hole in the bottom as shown in pic. Is this normal or something that I should be concerned about? 2. These look like stock wastegates - do I need to sync/adjust them prior to install? (are they even adjustable?) What is recommended for this - I have an EBC and there is 91 octane fuel in my area. I don't plan to run any higher than 12 psi since I'll be using a Specialty Z EPROM. 3. Notice in the picture just below the vacuum hose nipple, the crimping is bent. Should this be addressed or is it a non-issue? ________________Sig Separator________________________ Parting out my entire 1990 twin turbo! Please email me for needed parts!
Follow Ups	Sport500 pre-install questions - bartz32tt 10:35:45 06/18/13 Answers - Woody75 (Denver) 11:48:30 06/18/13 Awesome - thanks! (n/m) - bartz32tt 12:27:13 06/18/13 Woody is 100% right however, if you have bigger injectors - John (MD) 20:58:26 06/18/13 Should I be looking into adjustable waste gates to run 12psi - bartz32tt 22:37:17 06/18/13
Post a Followup	You cannot reply to this message because you are not logged in.