TwinTurbo.NET: Nissan 300ZX forum - Did you leave any rags or tape anywhere in the intake or
Subject
Did you leave any rags or tape anywhere in the intake or
Posted by
TTZ2NV(EPTmotorsports)
on June 18, 2013 at 10:27 AM
This message has been viewed
269
times.
In Reply To
new motor, new problems
posted by youngbloodz
on June 16, 2013 at 07:46 PM
Message
Turbo pipes? Sounds like you might of.
Follow Ups
new motor, new problems
-
youngbloodz
19:46:03 06/16/13
plugs are all dry but covered in carbon, so its not fuel
-
youngbloodz
20:23:19 06/16/13
Try new plugs. You have an inductive timing light, correct?
-
ZaXxon
20:37:13 06/16/13
Alternator is fine, there isn't an issue with it...
-
youngbloodz
21:20:16 06/16/13
The rich condition may be a result of an issue with a MAF
-
ZaXxon
04:16:43 06/17/13
*their* (n/m)
-
youngbloodz
21:21:40 06/16/13
Might sound stupid..
-
AHos(Chicago)
21:28:13 06/16/13
I labeled them all with sharpie when I took them off
-
youngbloodz
21:36:09 06/16/13
you light issue sounds like an earthing problem...
-
Medallion Man
05:15:16 06/17/13
I labeled them all with sharpie when I took them off
-
youngbloodz
21:58:58 06/16/13
Could it be an ecu/tune issue? (n/m)
-
TriniTT
06:49:21 06/17/13
On that note,
-
Woody75 (Denver)
11:20:52 06/17/13
anything is possible. but my entire ecu was sent to sz for
-
youngbloodz
12:01:52 06/17/13
A large vacuum vacuum leak explain your problems
-
Antihero
11:47:20 06/17/13
I was thinking that too, but I disconnected the brake
-
youngbloodz
12:06:57 06/17/13
You might have a combination of issues. Fuel out of the
-
CmyZ
15:18:19 06/17/13
I'm not getting raw fuel out of the tailpipe, just REALLY
-
youngbloodz
16:17:09 06/17/13
You might have a combination of issues. Fuel out of the
-
CmyZ
16:02:11 06/17/13
update, rich issue fixed, still diognosing the others
-
youngbloodz
17:56:41 06/17/13
So it was dumpping fuel for two...good. (n/m)
-
CmyZ
19:57:05 06/17/13
Did you leave any rags or tape anywhere in the intake or -
TTZ2NV(EPTmotorsports)
10:27:50 06/18/13
Post a
Followup
You cannot reply to this message because you are not
logged in
.