Subject	Re: In datascan active test, what happens when you adjust the
Posted by	Da Flash on June 08, 2013 at 3:54 PM
	This message has been viewed 368 times.
In Reply To	In datascan active test, what happens when you adjust the posted by Evan_Wright (Ca) on June 08, 2013 at 02:53 PM
Message	If I take the AAC value down to 0, it idles @ ~700. I haven't tried taking it to 100%. I've come to the conclusion that the ECU is indeed telling the AAC to idle at 40%, I just don't know why! TPS is new and adjusted to .42, it goes to 3.98 at WOT. The throttle switch is closed but will show open at anything above ~.48. THE CTS is new and ohms out correctly at the 3 different temps in the FSM. I'm going to figure out how to post pics, and post a screen shot of startup and warmed up idle. This is quite frustrating but, this car will not beat me!! If you have any more suggestions, I'm all ears!! Thanks!
Follow Ups	Throttle body adjustment question - Da Flash 21:40:12 06/07/13 i bet you have a bad ecu (n/m) - Dane (Houston) 04:13:28 06/08/13 Re: i bet you have a bad ecu - Da Flash 12:27:54 06/08/13 swaping in a good know one is the easiest way - Dane (Houston) 02:17:28 06/10/13 Re: i bet you have a bad ecu - Da Flash 10:59:03 06/12/13 Do you have any diagnostic software like Nissan datascan? - Evan_Wright (Ca) 09:46:09 06/08/13 Re: Do you have any diagnostic software like Nissan datascan? - Da Flash 12:18:59 06/08/13 In datascan active test, what happens when you adjust the - Evan_Wright (Ca) 14:53:56 06/08/13 Re: In datascan active test, what happens when you adjust the - Da Flash 15:54:23 06/08/13 Re: Re: In datascan active test, what happens when you adjust the - Da Flash 15:56:08 06/08/13 Sounds like you have done a good amount of troubleshooting. - Evan_Wright (Ca) 21:10:20 06/08/13
Post a Followup	You cannot reply to this message because you are not logged in.