Subject	you measured it wrong
Posted by	aliaZ on June 03, 2013 at 1:05 AM
	This message has been viewed 194 times.
In Reply To	the link posted by doanh on June 03, 2013 at 12:07 AM
Message	you don't need the vacuum device to check the push rod length measure the length of the rod relative to the master cylinder interface at the firewall
Follow Ups	weird brake problem - follow up - doanh 23:59:23 05/30/13 check your output rod length - aliaZ 00:26:14 05/31/13 Re: check your output rod length - doanh 07:53:43 05/31/13 Re: check your output rod length - doanh 08:34:30 05/31/13 Re: check your output rod length - doanh 21:37:30 05/31/13 so...what was the result? - aliaZ 05:48:27 06/01/13 output rod length - doanh 10:21:07 06/01/13 output rod length - doanh 11:23:49 06/01/13 output rod length - doanh 15:53:16 06/01/13 did you even bother to look at the link I gave you? - aliaZ 06:56:15 06/02/13 the link - doanh 00:07:03 06/03/13 you measured it wrong - aliaZ 01:05:04 06/03/13 Re: you measured it wrong - doanh 00:37:23 06/06/13 Brake Booster check - doanh 17:01:34 05/31/13 Re: Brake Booster check - doanh 18:34:29 06/01/13 Brake Booster check - doanh 17:46:37 05/31/13 Re: weird brake problem - follow up - jaidieray 19:09:31 05/31/13 ABS actuators - doanh 21:39:13 05/31/13 Re: ABS actuators - doanh 18:32:00 06/01/13 brake lights stay on? bad brake booster? - doanh 20:54:40 06/01/13
Post a Followup	You cannot reply to this message because you are not logged in.