Subject	Brake pedal goes to the floor after brake job
Posted by	d_flore on June 02, 2013 at 9:24 AM
	This message has been viewed 248 times.
Message	After installing new pads, rotors, and front calipers (prev ones seized) the pedal goes all the way to the floor. The only way I get brakes is if I pump it a few times but then it will eventually sink. I bled the brakes in proper sequence until there was no air. I went around the car 3 times to be sure. There are no fluid leaks when i pump the brakes. Any help is greatly appreciated.
Follow Ups	Brake pedal goes to the floor after brake job - d_flore 09:24:09 06/02/13 I had to do mine over and over and over - ChaseGrayTT 09:32:11 06/02/13 I made sure to never run low in the master cylinder however - d_flore 09:58:51 06/02/13 There are bleeders on the ABS module you need to do - ttsmokin 13:15:09 06/02/13 Yep that's it! (n/m) - ChaseGrayTT 19:09:34 06/02/13 Wow thanks for all of the help guys!! (n/m) - d_flore 22:38:16 06/02/13
Post a Followup	You cannot reply to this message because you are not logged in.