TwinTurbo.NET: Nissan 300ZX forum - They're Bosch, ordered from Concept Z. They're sweeping
Subject
They're Bosch, ordered from Concept Z. They're sweeping
Posted by
Attridge_300ZX
on May 30, 2013 at 12:29 PM
This message has been viewed
238
times.
In Reply To
What brand O2? OEM, NGK, ? Even though new check the >>
posted by ZUL8TR
on May 30, 2013 at 10:16 AM
Message
back and forth at 2k rpm like they're supposed to. I have OHM'd my injectors they all check out good.
Follow Ups
Possible fuel issue? I feel the same pulsing in my seat as
-
Attridge_300ZX
07:39:43 05/29/13
Did you do the heated o2 sensor test?
-
300ZMang
09:12:27 05/29/13
They're brand new O2's, just installed them last night. As
-
Attridge_300ZX
10:09:42 05/29/13
Ok, how about spark plugs, what kind and age?
-
300ZMang
11:05:54 05/29/13
They're NGK PFR6B-11B gaped to .035" probably 3 years old (n/m)
-
Attridge_300ZX
12:58:02 05/29/13
What brand O2? OEM, NGK, ? Even though new check the >>
-
ZUL8TR
10:16:54 05/30/13
They're Bosch, ordered from Concept Z. They're sweeping -
Attridge_300ZX
12:29:15 05/30/13
Swing is OK but the voltage swing is more important>>
-
ZUL8TR
07:04:16 06/02/13
Ok I'll check the voltage (n/m)
-
Attridge_300ZX
16:58:53 06/02/13
Also.... even though your injectors OHM out correctly
-
300ZMang
09:13:02 05/29/13
Also with Nissan data scan it doesn't fluctuate between
-
Attridge_300ZX
14:07:16 05/29/13
Once fully warm the O2 sensors should fluctuate.
-
Tanley
19:07:31 05/29/13
Oh ok, my O2's probably weren't warm yet. Did a boost leak
-
Attridge_300ZX
23:29:09 05/29/13
Why is your fuel pump priming when you turn off
-
njz
05:24:57 05/30/13
I don't know why, that's why I'm asking (n/m)
-
Attridge_300ZX
06:36:44 05/30/13
Mine did that too
-
300ZMang
07:19:16 05/30/13
I have a fairly new OEM gas cap as well (n/m)
-
Attridge_300ZX
09:38:29 05/30/13
Re: Possible fuel issue? I feel the same pulsing in my seat as
-
ALee
22:34:47 05/31/13
I'll have a look at the spark plugs than (n/m)
-
Attridge_300ZX
16:58:28 06/02/13
Post a
Followup
You cannot reply to this message because you are not
logged in
.