Subject	Valves were bent yes, did car run perfect? No....
Posted by	300ZMang on May 29, 2013 at 7:13 AM
	This message has been viewed 219 times.
In Reply To	VG30DE engines are interference engines. posted by RZturbo on May 28, 2013 at 07:58 PM
Message	But it started, and drove after new TB and accessories were installed, it was actually pretty damn smooth considering what happened. What might have saved me was: - I was cruising at 60mph (no load on engine and lower rpm's) - after car stalled out, I didn't try to crank it over, I simply pulled over and called for a tow.
Follow Ups	will a broken tiiming belt cause engine seizure? - jjamez 11:14:32 05/28/13 ...... - ChaseGrayTT 11:27:33 05/28/13 Do what Chase said - 300ZMang 12:24:43 05/28/13 If T-belt snapped, the pistons will hit and bent the valves - RZturbo 12:33:36 05/28/13 Not entirely true - 300ZMang 12:43:36 05/28/13 VG30DE engines are interference engines. - RZturbo 19:58:01 05/28/13 Valves were bent yes, did car run perfect? No.... - 300ZMang 07:13:24 05/29/13 mine spun just fine. (n/m) - Antihero 13:32:20 05/28/13 looks like coolant in the oil - jjamez 13:05:50 05/28/13 unsure about tension but timing belt not broken (n/m) - jjamez 13:11:22 05/28/13 compression test on 6/2012 - jjamez 13:14:50 05/28/13 those numbers are not the worst. (n/m) - Antihero 13:33:04 05/28/13 Looks like your timing belt is off a tooth or two - ZXoltan 13:52:45 05/31/13 timing belt was replaced by shop several years ago (n/m) - jjamez 15:56:20 05/31/13 Sure, and from your original post you have T-belt concerns - ZXoltan 11:07:08 06/02/13 Did you overheat the car? - CameronSF 13:29:47 05/28/13 no, it didn't overheat, just stalled (n/m) - jjamez 13:30:50 05/28/13
Post a Followup	You cannot reply to this message because you are not logged in.