Subject	With a good idler stud...
Posted by	baggar11 on May 26, 2013 at 4:42 PM
	This message has been viewed 296 times.
In Reply To	You have a bent/Loose Idler Stud.. posted by Cjw3 on May 26, 2013 at 04:32 PM
Message	Will the timing belt naturally ride towards the front of all the gears and pulleys? -baggar11 1987 300zx n/a (sold) 1990 300zx TT
Follow Ups	Timing Belt rubbing and smoking - baggar11 15:18:30 05/26/13 Re: Timing Belt rubbing and smoking - wild_maxx 15:37:43 05/26/13 Yeah, both front and rear crank washers are installed. - baggar11 15:44:24 05/26/13 You have a bent/Loose Idler Stud.. - Cjw3 16:32:16 05/26/13 With a good idler stud... - baggar11 16:42:22 05/26/13 My 2 NA Belts wander a little, but like the front (n/m) - Cjw3 16:58:00 05/26/13 If everything checks out, do we want to install the belt - baggar11 17:04:50 05/26/13 The belt will center itself.. Something is Bent/Crooked. (n/m) - Cjw3 17:36:47 05/26/13 Update, here's where it's rubbing... - baggar11 16:23:06 05/26/13 Re: Update, here's where it's rubbing... - wild_maxx 16:29:20 05/26/13 Yeah, everything was flush. - baggar11 16:40:56 05/26/13 Make sure you don't have and idler pulley bent. (n/m) - ChaseGrayTT 17:47:03 05/26/13 Recently there have been some auto tensioners that - Evan_Wright (Ca) 17:52:37 05/26/13 Update: Found the problem - baggar11 18:18:39 05/26/13 Congrats! - OverZealous (CT) 23:21:00 05/26/13
Post a Followup	You cannot reply to this message because you are not logged in.