Subject	Yeah, everything was flush.
Posted by	baggar11 on May 26, 2013 at 4:40 PM
	This message has been viewed 272 times.
In Reply To	Re: Update, here's where it's rubbing... posted by wild_maxx on May 26, 2013 at 04:29 PM
Message	The 2 studs for the idler pulleys were replaced. It doesn't look like that is the issue. From what we can see, it looks like the belt is becoming unaligned after it hits the auto tensioner pulley. We did break the adjustment screw arm on the auto tensioner on assembly. So we used the old auto tensioner base. Is it possible this caused something? -baggar11 1987 300zx n/a (sold) 1990 300zx TT
Follow Ups	Timing Belt rubbing and smoking - baggar11 15:18:30 05/26/13 Re: Timing Belt rubbing and smoking - wild_maxx 15:37:43 05/26/13 Yeah, both front and rear crank washers are installed. - baggar11 15:44:24 05/26/13 You have a bent/Loose Idler Stud.. - Cjw3 16:32:16 05/26/13 With a good idler stud... - baggar11 16:42:22 05/26/13 My 2 NA Belts wander a little, but like the front (n/m) - Cjw3 16:58:00 05/26/13 If everything checks out, do we want to install the belt - baggar11 17:04:50 05/26/13 The belt will center itself.. Something is Bent/Crooked. (n/m) - Cjw3 17:36:47 05/26/13 Update, here's where it's rubbing... - baggar11 16:23:06 05/26/13 Re: Update, here's where it's rubbing... - wild_maxx 16:29:20 05/26/13 Yeah, everything was flush. - baggar11 16:40:56 05/26/13 Make sure you don't have and idler pulley bent. (n/m) - ChaseGrayTT 17:47:03 05/26/13 Recently there have been some auto tensioners that - Evan_Wright (Ca) 17:52:37 05/26/13 Update: Found the problem - baggar11 18:18:39 05/26/13 Congrats! - OverZealous (CT) 23:21:00 05/26/13
Post a Followup	You cannot reply to this message because you are not logged in.