Subject	Timing Belt done, No Start
Posted by	baggar11 on May 25, 2013 at 10:32 PM
	This message has been viewed 219 times.
Message	Just finished doing a 120k service on my z and am at the point where I'm test starting it. Here's what happens... Turn key --> 600rpms --> 200rpms -->dead. Wait 15 seconds. Turn key again --> Revs to almost 2k, then slowly comes down and dies. While it was idling high and before it died it did sound healthy. It just won't stay running. I'm 100% positive on belt timing. I cleaned out the connections to the PTU and CAS already. I also tried starting with the TPS disconnected. Any suggestions? -baggar11 1987 300zx n/a (sold) 1990 300zx TT
Follow Ups	Timing Belt done, No Start - baggar11 22:32:11 05/25/13 It's gotta be either the PTU or CAS - ChaseGrayTT 08:43:40 05/26/13 running now - baggar11 15:07:35 05/26/13 Ah! So vacuum leak! Glad it's running! (n/m) - ChaseGrayTT 15:35:45 05/26/13
Post a Followup	You cannot reply to this message because you are not logged in.