Subject	Sure! I've done dozens of sets. What all would you like to
Posted by	TriniTT on May 25, 2013 at 12:59 PM
	This message has been viewed 185 times.
In Reply To	Re: The stoptech teflon-coated stainless lines carried by most posted by daZed on May 25, 2013 at 10:15 AM
Message	know? It's relatively straight forward, the only special tools you need are a 10mm and 17mm line wrench which cost around $12 from harbor freight. You remove the 10mm line fitting from the old soft line on both ends, holding the soft line with the 17 line wrench. Then replace with the new one. Takes about 5-10 minutes per corner plus bleed time once installed. Cheers, JBrobst "A life spent making mistakes is not only more honorable, but more useful than a life spent doing nothing." George Bernard Shaw
Follow Ups	Installing AP Racing BBK .. what is the preferred - daZed 14:57:58 05/24/13 The stoptech teflon-coated stainless lines carried by most - TriniTT 16:07:07 05/24/13 Re: The stoptech teflon-coated stainless lines carried by most - daZed 10:15:24 05/25/13 Sure! I've done dozens of sets. What all would you like to - TriniTT 12:59:03 05/25/13 Installation instructions should come with the setup. - TriniTT 13:20:23 05/25/13 Re: Installation instructions should come with the setup. - daZed 22:33:21 05/25/13 If you run into any snags, shoot me an email. (n/m) - TriniTT 10:18:00 05/26/13
Post a Followup	You cannot reply to this message because you are not logged in.