Subject	Re: removing wire harness
Posted by	parrotheadz on May 22, 2013 at 9:37 AM
	This message has been viewed 154 times.
In Reply To	removing wire harness posted by PYROhafe on May 21, 2013 at 08:04 AM
Message	I unpin the small connector and tape the wires down to the main harness and tape over the main plug to make it smooth. just make sure you label the wires that you unpin take pictures and a couple of the wires are very close to the same so put a mark with a sharpie on one of the two. good luck.
Follow Ups	removing wire harness - PYROhafe 08:04:19 05/21/13 Take a large pry bar and slightly bend the firewall - Summeronthechain (MN) 09:11:46 05/21/13 I usually take a long flat head screw driver and chisel away - Krazyd27(Houston) 10:16:26 05/21/13 Re: removing wire harness - parrotheadz 09:37:25 05/22/13 Re: removing wire harness - ariz 23:15:09 05/22/13
Post a Followup	You cannot reply to this message because you are not logged in.