Subject	I usually take a long flat head screw driver and chisel away
Posted by	Krazyd27(Houston) on May 21, 2013 at 10:16 AM
	This message has been viewed 103 times.
In Reply To	Take a large pry bar and slightly bend the firewall posted by Summeronthechain (MN) on May 21, 2013 at 09:11 AM
Message	At the metal bracket until it separates from the firewall and bend It away. This has been my easiest method so far. No damage done to the firewall. Be cautious this takes practice without damaging the AC lines that are near the metal plate inside.
Follow Ups	removing wire harness - PYROhafe 08:04:19 05/21/13 Take a large pry bar and slightly bend the firewall - Summeronthechain (MN) 09:11:46 05/21/13 I usually take a long flat head screw driver and chisel away - Krazyd27(Houston) 10:16:26 05/21/13 Re: removing wire harness - parrotheadz 09:37:25 05/22/13 Re: removing wire harness - ariz 23:15:09 05/22/13
Post a Followup	You cannot reply to this message because you are not logged in.