Subject	Take a large pry bar and slightly bend the firewall
Posted by	Summeronthechain (MN) on May 21, 2013 at 9:11 AM
	This message has been viewed 106 times.
In Reply To	removing wire harness posted by PYROhafe on May 21, 2013 at 08:04 AM
Message	from the engine bay side. But, since you are replacing it. I would just cut it.
Follow Ups	removing wire harness - PYROhafe 08:04:19 05/21/13 Take a large pry bar and slightly bend the firewall - Summeronthechain (MN) 09:11:46 05/21/13 I usually take a long flat head screw driver and chisel away - Krazyd27(Houston) 10:16:26 05/21/13 Re: removing wire harness - parrotheadz 09:37:25 05/22/13 Re: removing wire harness - ariz 23:15:09 05/22/13
Post a Followup	You cannot reply to this message because you are not logged in.