Subject	Re: do cylinder drop test
Posted by	speedy z on May 15, 2013 at 9:07 AM
	This message has been viewed 166 times.
In Reply To	do cylinder drop test posted by Dane (Houston) on May 15, 2013 at 02:16 AM
Message	it is strange. only happened since the fuel pressure regulator was swapped. and it is instant. i reset the ecu. unplugged battery. never even tries to boost when warm. only about 3psi of boost. JWT ecu possible less safety boost? just one thing after another.
Follow Ups	Need help with possible safety boost. followed all tech - speedy z 22:27:50 05/14/13 hmm.. safety boost usually tops out at 7 psi (n/m) - BarryGZX 01:43:07 05/15/13 do cylinder drop test - Dane (Houston) 02:16:28 05/15/13 Re: do cylinder drop test - speedy z 09:07:41 05/15/13 ecu has no control over how much safety boost just on or off - Dane (Houston) 13:56:28 05/15/13 would low fuel pressure limit the boost like this ?? - speedy z 16:11:16 05/15/13 Possibly, but it would cause all sorts of other issues - Summeronthechain (MN) 09:38:53 05/16/13 I found that, in my experience with my 92' boost solenoids, - ZTicket(Dallas) 08:36:54 05/15/13 Very well could be your stock boost solenoids. - DVDBURN (MD) 15:58:22 05/15/13 Maybe you replaced the regulator with a dampner - Krazyd27(Houston) 16:51:54 05/15/13 Re: Maybe you replaced the regulator with a dampner - speedy z 17:01:55 05/15/13 Disconnect the wires going to them and drive around - Summeronthechain (MN) 09:40:14 05/16/13 ~32 psi fuel pressure after ther fuel filter. - speedy z 18:56:52 05/15/13
Post a Followup	You cannot reply to this message because you are not logged in.