Subject	NEED HELP... Long story
Posted by	krstull93 on May 14, 2013 at 10:20 PM
	This message has been viewed 132 times.
Message	So I finished up everything like cas change to aem disc and aem EMS series 2 while the car was on the trailer Sunday. Left out Monday morning to get tuned and while I was there I found out cylinder 1 was cutting out/not sparking. The tuner narrowed it down to either the ptu or the EMS output. He tuned it driveable so we called it a day and went home. Today I pulled the ptu off my spare NA motor (same part number) and installed on my car. Didn't even try to fire on any cylinders. I switched back to the other ptu while cleaning connectors etc and cylinder 1 worked (did the pull plug to lower idle test). But it eventually cut out again. Not sure what's going on. I called aem and they said it was rare for outputs to not work. Any advise? My next step is to scope it.
Follow Ups	NEED HELP... Long story - krstull93 22:20:11 05/14/13 Not to take away focus on your problem, but - BarryGZX 01:51:05 05/15/13 Re: Not to take away focus on your problem, but - krstull93 16:22:38 05/15/13 Re: Not to take away focus on your problem, but - krstull93 17:02:32 05/15/13 if there is a ptu subharness it could be an issue - Dane (Houston) 14:04:57 05/15/13 Update - krstull93 17:04:18 05/15/13 ohm out that injector - Dane (Houston) 04:18:40 05/19/13
Post a Followup	You cannot reply to this message because you are not logged in.