Subject	Re: Steel wool not recommended on an assembled engine
Posted by	1995z32tt on May 09, 2013 at 10:23 PM
	This message has been viewed 130 times.
In Reply To	Steel wool not recommended on an assembled engine posted by ZXoltan on May 09, 2013 at 09:33 PM
Message	ya i was thinking about just pouring some oil down into the top of the cylinder and then jet vacking it out to remove any fibers but ya i really dont want to go about using steel whool
Follow Ups	help cylinder wall rust have pics advice pleaseeee - 1995z32tt 19:56:46 05/09/13 . - Zvil (FL) 20:08:46 05/09/13 If it was my motor.. I'd hone it - Cjw3 20:59:50 05/09/13 Re: help cylinder wall rust have pics advice pleaseeee - 1995z32tt 20:12:39 05/09/13 Steel wool not recommended on an assembled engine - ZXoltan 21:33:41 05/09/13 Re: Steel wool not recommended on an assembled engine - 1995z32tt 22:23:03 05/09/13 Hone it to see if it will clean up. - JMartz 10:26:42 05/10/13
Post a Followup	You cannot reply to this message because you are not logged in.