Subject	How to run closed LOOP?!
Posted by	krstull93 on May 08, 2013 at 5:53 PM
	This message has been viewed 138 times.
Message	I have done a lot of searching and found one thread of how to run a closed loop AEM wideband or any, they said use pin 115 if I remember correctly? Is this correct? Just need to know where to hook the 5v wire. I am going monday to get tuned on AEM EMS series 2.
Follow Ups	How to run closed LOOP?! - krstull93 17:53:06 05/08/13 115 is the ground for the O2 heaters..... - zx299 21:29:45 05/09/13 Re: 115 is the ground for the O2 heaters..... - krstull93 21:00:52 05/10/13 55 is the L/H sensor signal..... - zx299 00:58:30 05/11/13 Re: 55 is the L/H sensor signal..... - krstull93 12:11:06 05/11/13 Re: 55 is the L/H sensor signal..... - krstull93 14:40:50 05/11/13
Post a Followup	You cannot reply to this message because you are not logged in.