Subject	Hey, it's not the hight of the bolt that's important,
Posted by	Medallion Man on May 04, 2013 at 2:58 AM
	This message has been viewed 158 times.
In Reply To	Adjustment height for throttle leaver stopper bolt??? posted by LivinTheDream on May 03, 2013 at 05:42 PM
Message	it's the position of the butterfly in the TB's. The bolts should be at the right hight to ensure that the butterflys are closed just the right amount (i.e. not so they jam). The way to make sure that are the right amount is to take the intake pipe off and do calibration for both TB's so that they are closing the right amount and synchronised. this involves adjustment of both bolts on either side of the plenum and possibly the one in the middle and the throttle cable one as well, also a good time to clean the TB's. there are right-ups on this.. I hope that helps and best of luck. :¬)
Follow Ups	Adjustment height for throttle leaver stopper bolt??? - LivinTheDream 17:42:17 05/03/13 Hey, it's not the hight of the bolt that's important, - Medallion Man 02:58:41 05/04/13 adjust it until your throttle blades open up fully at WOT - aliaZ 06:53:53 05/04/13
Post a Followup	You cannot reply to this message because you are not logged in.