Subject	use variable speed 3/8" or 1/2" drill and >>
Posted by	ZUL8TR on May 03, 2013 at 5:59 AM
	This message has been viewed 499 times.
In Reply To	Appreciate the help guys! posted by dvice on May 02, 2013 at 05:34 PM
Message	set rpm and stroke to get a cross hatch pattern with 40 to 45 degree angle between up spiral and down spiral lines like this. [ http://www.google.com/imgres?q=cylinder+cross+hatching+tool&um=1&sa=N&hl=en&tbm=isch&tbnid=9fLV25GA_NBMeM:&imgrefurl=http://www.hastingsmfg.com/ServiceTips/cylinder_bore_refinishing.htm&docid=VMP8QRLtvOkHhM&imgurl=http://www.hastingsmfg.com/ServiceTips/images/p76.gif&w=450&h=194&ei=x5WDUe-NJoSg8QTViIHoAQ&zoom=1&biw=1440&bih=673&iact=rc&dur=235&page=1&tbnh=117&tbnw=256&start=0&ndsp=30&ved=1t:429,r:26,s:0,i:167&tx=126&ty=50 ] Place the hone in the bore and remove from the bore with drill turning. Usually about 400 rpm and stroke up and down 1 sec in 1 sec out. Use lots of the correct lube lube. Do not clean with solvents, use soapy hot water and scrub with a toilet bowl cleaner type brush. Then wipe with a lint free cloth till there are no deposits. Then wipe on motor oil to keep rust from forming. Keep everything super clean. ZUL8TR in Orlando,FL
Follow Ups	Honing for OEM rings - dvice 17:06:25 05/01/13 I dont recommend using that tool. You should try the tool - Krazyd27(Houston) 17:58:36 05/01/13 Re: Honing for OEM rings - Tech@EPR 18:07:17 05/01/13 Re: Honing for OEM rings - Tech@EPR 18:13:07 05/01/13 Appreciate the help guys! - dvice 17:34:45 05/02/13 Re: Appreciate the help guys! - Tech@EPR 18:53:08 05/02/13 Also it makes things easier removing the oil squirters - Krazyd27(Houston) 22:31:51 05/02/13 use variable speed 3/8" or 1/2" drill and >> - ZUL8TR 05:59:20 05/03/13
Post a Followup	You cannot reply to this message because you are not logged in.