Subject	Re: Appreciate the help guys!
Posted by	Tech@EPR on May 02, 2013 at 6:53 PM
	This message has been viewed 421 times.
In Reply To	Appreciate the help guys! posted by dvice on May 02, 2013 at 05:34 PM
Message	just remember when you go to use it that you're motion going up and down the is even and straight. Drill speed doesn't need to be "haul ass" mode...a good medium speed is sufficient Ep Racing | Create Your Badge
Follow Ups	Honing for OEM rings - dvice 17:06:25 05/01/13 I dont recommend using that tool. You should try the tool - Krazyd27(Houston) 17:58:36 05/01/13 Re: Honing for OEM rings - Tech@EPR 18:07:17 05/01/13 Re: Honing for OEM rings - Tech@EPR 18:13:07 05/01/13 Appreciate the help guys! - dvice 17:34:45 05/02/13 Re: Appreciate the help guys! - Tech@EPR 18:53:08 05/02/13 Also it makes things easier removing the oil squirters - Krazyd27(Houston) 22:31:51 05/02/13 use variable speed 3/8" or 1/2" drill and >> - ZUL8TR 05:59:20 05/03/13
Post a Followup	You cannot reply to this message because you are not logged in.