Subject	Looks like the correct bushing
Posted by	timz on April 27, 2013 at 4:33 PM
	This message has been viewed 216 times.
In Reply To	Wrong Pilot bushing?? I appreciate if someone respond within posted by nonstopna on April 27, 2013 at 04:18 PM
Message	Probably when you tap it in, it get distorted a little. No big deal. Just use sand paper to sand down the alighnment tool a little until it will fit snugly into the bushing. The input shaft of the trans will fit in for sure.
Follow Ups	Wrong Pilot bushing?? I appreciate if someone respond within - nonstopna 16:18:23 04/27/13 Looks like the correct bushing - timz 16:33:21 04/27/13 Umm...I'll try it out but It looked like it wasn't close to - nonstopna 16:46:49 04/27/13 Yep... you were right. (n/m) - nonstopna 21:19:48 04/27/13 Mine was similar. I used some sandpaper and sanded alignment - Summeronthechain (MN) 20:58:22 04/27/13 What am I missing here? 2 guys say to sand down the - zellamay 21:51:43 04/27/13 They are just saying he may have distorted the plastic - evan_aggie 23:31:01 04/27/13 You are right but the sanding was so minimal that - nonstopna 23:35:35 04/27/13 ^^^that's what she said (n/m) - z-u-later 07:54:12 04/28/13
Post a Followup	You cannot reply to this message because you are not logged in.