Subject	Camber plates don't work on our Z
Posted by	ttsmokin on April 23, 2013 at 1:31 PM
	This message has been viewed 170 times.
In Reply To	Strut Gas leak question during coilover install posted by SMAZ (OKC) on April 23, 2013 at 09:25 AM
Message	Not too sure on the oil leak, I will let someone else chime in. Sounds like they might have been worn as they should not really flex when you unbolt them. Never seen that. You need upper control arms to adjust camber front and rear. You find the 7k/5k too stiff, even on the softest dampening settings? Perhaps you are better off with lowering springs, your roads must be very rough. The 7k/5k rides great to me.
Follow Ups	Strut Gas leak question during coilover install - SMAZ (OKC) 09:25:54 04/23/13 Camber plates don't work on our Z - ttsmokin 13:31:46 04/23/13 I'm lowered to the .8" mark same as Eibach for now. - SMAZ (OKC) 14:20:32 04/23/13 To specify you're talking about top mount camber plates? - white22sky 17:05:30 04/23/13 Yeah top mount. 300degree camber shims work for sure! (n/m) - ttsmokin 17:06:49 04/23/13 Yes, sorry 300 degrees of camber protection! (n/m) - SMAZ (OKC) 18:52:50 04/23/13 lol. Not really but nice wording. (n/m) - white22sky 07:46:24 04/24/13
Post a Followup	You cannot reply to this message because you are not logged in.