Subject	Tensioner Stud
Posted by	Z32Only on April 20, 2013 at 8:33 PM
	This message has been viewed 160 times.
Message	The stud for the Tensioner Pulley is stripped out, I was wondering if I could just place a bolt in it's place, or it has to be a stud on there for some reason...
Follow Ups	Tensioner Stud - Z32Only 20:33:58 04/20/13 buy a new stud... a bolt will back out in time! - JonnyZ(SoCal) 00:46:06 04/21/13 "For some reason"? If you think about it, studs operate - zellamay 10:32:02 04/21/13 Not the place to get cheap - replace the stud (n/m) - RICH1 06:44:01 04/24/13
Post a Followup	You cannot reply to this message because you are not logged in.