Subject	This isn't normal, is it!? ... FPR hose to Fuel Supply Pipe.
Posted by	NismoDHS on April 16, 2013 at 3:44 PM
	This message has been viewed 367 times.
Message	So...I was replacing the fuel hose that goes from the Fuel Pressure Regulator to the Fuel Feed Supply Pipe and when I finally got the old hose off, I couldn't believe how close they were together and also how offset they were. If I remember correctly from my old NA, the 2 ends should line up pretty straight, correct?...and maybe a bit more distance between them also, maybe not. The old hose I took off is bent down (almost creased) just to make the connection. (wonder if this was a reason to my warm/hot starts requiring me to hit the gas)...so does anyone else's Z fuel parts line up like this also?
Follow Ups	This isn't normal, is it!? ... FPR hose to Fuel Supply Pipe. - NismoDHS 15:44:03 04/16/13 your lines bent, just straighten and separate slightly. - white22sky 21:04:17 04/16/13 Or put a washer or two under the bolt that holds that end - jzack 18:32:53 04/17/13 mine were lined up, but were super close - fuzzymonkey 15:47:00 04/17/13
Post a Followup	You cannot reply to this message because you are not logged in.