TwinTurbo.NET: Nissan 300ZX forum - Re: Well, what was it? What was wrong? Feedback helps others.
People Seeking Info
 
   


     
Subject Re: Well, what was it? What was wrong? Feedback helps others.
     
Posted by Z-Driver (FIN) on April 15, 2013 at 1:37 PM
  This message has been viewed 348 times.
     
In Reply To Well, what was it? What was wrong? Feedback helps others. (n/m) posted by zellamay on April 13, 2013 at 04:24 PM
     
Message This sounds a little bit crazy but this is what I tried:
I loosed starter motor's nut and screw. I removed the cable which is connected from magnetic switch to the starter. I connected battery stright to the magnetic switch to keep it open. So I moved the starter motor and searched for a good adjust on the flywheel. When I found a good position between pinion and flywheel I tighted the nut and screw of the starter. Finally I removed my DIY connections and reconnected all cables and connector. Untill this moment I wasnt sure does this helps I just got in the drivers side and Start the car and I starts and run very well.

I hope this will helps someone somewhere in future.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.