Subject	New style injector question.
Posted by	GotTwins90 on April 13, 2013 at 5:02 PM
	This message has been viewed 210 times.
Message	I got Bernie's new style injector conversion kit and put it in today. I got the plenum pulled no problem and got them in no problem. The problem ive come across is on the stock old style ones there is a metal cap with two screws holding it down onto the top of the injectors little brass plunger thing. These metal caps fit over the new ones but doesn't touch the brass plunger thing like the stock ones did. Also the screws would be to small.. The new ones already have a metal piece with two alan wrench bolts around it but they don't allow the old metal caps to go over the top of the injector. Any advice would help. I apologize if this doesn't make a lot of sense. Im stuck
Follow Ups	New style injector question. - GotTwins90 17:02:42 04/13/13 Maybe post a picture? Hard to follow what you stated.... (n/m) - jzack 22:43:36 04/13/13 You don't need to use the old caps. - Woody75 (Denver) 23:25:18 04/13/13 Sorry i meant something like this... - GotTwins90 10:40:01 04/14/13 Re: You don't need to use the old caps. - GotTwins90 11:41:12 04/14/13 Yes, I had the same thought but no probs here . (n/m) - Xteam300TT (South Tx ) 17:44:20 04/14/13 Here's a pic of my '91 changed to the new style: - NismoDHS 22:12:51 04/14/13
Post a Followup	You cannot reply to this message because you are not logged in.