Subject	You have described 2 problems: slipping clutch and
Posted by	zellamay on April 12, 2013 at 11:57 AM
	This message has been viewed 248 times.
In Reply To	Slipping clutch (master or actually the clutch) posted by hellraz0r1337 on April 12, 2013 at 09:52 AM
Message	bad master cylinder. So replace both. I wouldn't replace just the friction plate because an old weak pressure plate can be the cause of the slippage. Call Coz and ask him why he says that.
Follow Ups	Slipping clutch (master or actually the clutch) - hellraz0r1337 09:52:56 04/12/13 My .02 - Summeronthechain (MN) 10:07:05 04/12/13 Re: My .02 - hellraz0r1337 10:24:25 04/12/13 You don't have to have a aftermarket flywheel with SouthBend - Joe@ZSpeedperformance 13:04:23 04/14/13 Is my friction disk worn to far down? - hellraz0r1337 11:53:45 04/12/13 You have described 2 problems: slipping clutch and - zellamay 11:57:36 04/12/13 Re: You have described 2 problems: slipping clutch and - hellraz0r1337 12:05:59 04/12/13 Im looking at this clutch for my setup. - hellraz0r1337 15:52:30 04/12/13 It's hard to tell, but from pics your disk looks fine. - TriniTT 16:08:40 04/12/13 Thats a Centerforce Dual Friction Clutch. - nonstopna 16:21:51 04/12/13 Re: Thats a Centerforce Dual Friction Clutch. - hellraz0r1337 13:53:41 04/13/13 Are you basing this on the pressure plate stamping? - TriniTT 14:50:22 04/15/13 Agreed, I had this clutch in my TT. - TriniTT 14:53:01 04/15/13
Post a Followup	You cannot reply to this message because you are not logged in.