Subject	Thanks! Next I'll have to use my leak-down tester and hope
Posted by	evan_aggie on April 08, 2013 at 11:48 PM
	This message has been viewed 161 times.
In Reply To	It will still line up. posted by Woody75 (Denver) on April 08, 2013 at 11:34 PM
Message	that my valves didn't get smashed. Then if everything is good, I should be able to button it up. If there is valve and piston contact, is it generally wise to rebuild the bottom end too?
Follow Ups	Timing Belt Adjustment Question - evan_aggie 23:20:50 04/08/13 It will still line up. - Woody75 (Denver) 23:34:46 04/08/13 Thanks! Next I'll have to use my leak-down tester and hope - evan_aggie 23:48:46 04/08/13 my opinion - wickdGSXR 10:20:29 04/09/13 It's standard proceedure to rotate forward and back - Woody75 (Denver) 10:27:21 04/09/13 Gap started out close to 2.5-3mm and now looks closer to 4mm - evan_aggie 13:01:43 04/09/13 Tip: try to slip a 4mm allen key in there for an - ConVerTT 08:33:18 04/10/13 2nd works great. (n/m) - jzack 18:00:50 04/10/13 go forward 2 crank revs, back 4, forward 2 and you will be.. - rmp459 10:44:46 04/09/13
Post a Followup	You cannot reply to this message because you are not logged in.