Subject	Finally turned! I threw caution to the wind and torched it
Posted by	evan_aggie on April 07, 2013 at 10:03 PM
	This message has been viewed 190 times.
In Reply To	one more thing you might want to try is posted by Zvil (FL) on April 07, 2013 at 09:39 PM
Message	upside down for about 20 seconds. The flame didn't go out. I expected the two nuts to turn as they did before, but I guess the heat broke it free just enough to start turning the stud! Finally. Also, the studs are to be tightened "snug" right? I put some blue loctite on the first stud and just tightened it with a small wrench until it wouldn't turn much more with a small wrench.
Follow Ups	Removing stuck idler studs? - evan_aggie 22:54:01 04/04/13 Sounds pretty stuck. I've always been able to remove them - Evan_Wright (Ca) 23:03:25 04/04/13 I seriously considered not trying to swap them in fear - evan_aggie 23:06:10 04/04/13 Re: Sounds pretty stuck. I've always been able to remove them - JSD-ZX 01:09:18 04/09/13 tighten two nuts together - Khronik 01:20:35 04/05/13 Overnight PB blaster soak appeared to work. Man I hate - evan_aggie 19:59:49 04/05/13 Heat up the studs, then spray penetrent while still hot (n/m) - ZaXxon 08:26:26 04/05/13 I'll give that a try when I get home this afternoon. Thanks. (n/m) - evan_aggie 08:58:44 04/05/13 the way I do it - Zvil (FL) 16:08:46 04/05/13 I don't weld. The longer stud is still stuck. Do you think - evan_aggie 17:43:48 04/07/13 Who knows.... you might get lucky - Zvil (FL) 21:34:19 04/07/13 one more thing you might want to try is - Zvil (FL) 21:39:16 04/07/13 Finally turned! I threw caution to the wind and torched it - evan_aggie 22:03:21 04/07/13 i came across some studs that were apparently red loctited - gt300zxtt(HI) 02:07:37 04/06/13 Both nuts keep spinning on the bottom stud. I tried to get - evan_aggie 17:58:16 04/07/13
Post a Followup	You cannot reply to this message because you are not logged in.