Subject	Followup
Posted by	Cjw3 on April 06, 2013 at 10:24 PM
	This message has been viewed 297 times.
In Reply To	Rear Hub Problem posted by Cjw3 on April 06, 2013 at 04:34 PM
Message	I came up with a solution.. I whipped up a brass ring 63*58*12MM Wide. Then Sloshed a little RTV on the Surfaces to stick it all together.. And Assembled.. After I get this side assembled, I'll look at the other side and see what's happning over there.. Still would like to know what this is about.. Is this a NA with TT Parts thing? Cj
Follow Ups	Rear Hub Problem - Cjw3 16:34:48 04/06/13 Followup - Cjw3 22:24:06 04/06/13 How tight was the fit of the brass ring on the shaft? - ZUL8TR 17:28:14 04/08/13 What is the condition of the inner and outer joints on>>> - ZUL8TR 17:32:36 04/08/13 Considered it.. - Cjw3 17:56:04 04/08/13 Could the axle be a misfit replacement? (n/m) - Gordo 93TT Daytona 09:39:53 04/09/13
Post a Followup	You cannot reply to this message because you are not logged in.