Subject	I did something similar when I added extra 300Degree shims.
Posted by	Gordo 93TT Daytona on April 05, 2013 at 11:13 AM
	This message has been viewed 783 times.
In Reply To	Has anyone worked out the change in camber angle .. posted by DaZedMan on April 02, 2013 at 02:24 PM
Message	The 300 Degree kit is design to compensate the Eibach 0.8" drop with 0.30" shims. My correction factor required 0.60 to 0.70 worth of shims which I fabricated. The drop measured at the wheel arch to wheel center was a little over an inch. I used an adjustable aftermarket UCA to determine how much we needed to push out the uprights, e.g., the extension of the UCA, for proper negative camber. That distance was then applied to the 300 Degree Kit by adding extra shims (totaling about 0.60 inches). The full thread click here: 300 Degree Camber Kit modification needed for camber setting _________________________________________________
Follow Ups	upper control arm bushing replacement? - DaZedMan 20:33:42 04/01/13 Re: front upper control arm bushing replacement? - DaZedMan 20:35:04 04/01/13 I swear the ES bushings are out there - Shiers69 09:28:20 04/02/13 I don't believe front upper CA bushings were included in - Inzane 11:30:50 04/02/13 They are not. (n/m) - Woody75 (Denver) 12:27:58 04/02/13 What are your coilovers set to? Stock height? - Woody75 (Denver) 09:37:14 04/02/13 KYB AGX shocks with stock NA springs - DaZedMan 14:19:54 04/02/13 Springs are deff past due and sagging causing the issue. (n/m) - Woody75 (Denver) 15:21:33 04/02/13 Front upper control arms are pretty robust. Failure is not - Gordo 93TT Daytona 10:51:48 04/02/13 Has anyone worked out the change in camber angle .. - DaZedMan 14:24:17 04/02/13 I did something similar when I added extra 300Degree shims. - Gordo 93TT Daytona 11:13:45 04/05/13 So the extra .2" drop required .3" of camber correction? - ZXoltan 04:58:00 04/06/13 Yea, I know it doesn't seem right, but all I can say is that - Gordo 93TT Daytona 19:27:45 04/06/13 I got a set of Whiteline FUCA bushings frm ZspeedPerformance - BoneZ (MD) 20:02:04 04/03/13
Post a Followup	You cannot reply to this message because you are not logged in.