Subject	+1 would any of you engine builders out there
Posted by	Zvil (FL) on April 02, 2013 at 7:32 PM
	This message has been viewed 384 times.
In Reply To	Curious if a crank is salvageable posted by BlackholeZ on April 02, 2013 at 11:39 AM
Message	recommend using one of these ? *disclaimer*: all that I say may be true or I may be completely wrong and I accept that.... please, it is your duty as another person on the internet to impolitely tell me how wrong I am :) "The dreaded 2nd windshiled wiper swipe when you turn it off its almost like tis showing you that it's boss, and it doesn't have to stop when you tell it to :("-College Boy (discussion on ptu relocation) "No good reason to put it there anyway. -Bernie (NoVA) False -vorpalZ False. -Bernie (NoVA) You're correct, there are 3 good reasons -vorpalZ False. -Bernie (NoVA) Wow, right again, just remembered another, make that 4 -vorpalZ" XD
Follow Ups	Curious if a crank is salvageable - BlackholeZ 11:39:24 04/02/13 The way I tell - Cjw3 15:45:46 04/02/13 If you have the crank ground, it will need to be re-nitrided (n/m) - ttsmokin 16:48:57 04/02/13 and at that point I would just find another crank. (n/m) - BlackholeZ 17:00:11 04/02/13 It's really hard to detect anything - BlackholeZ 19:11:46 04/02/13 +1 would any of you engine builders out there - Zvil (FL) 19:32:32 04/02/13 Re: Curious if a crank is salvageable - Tech@EPR 19:55:39 04/02/13 Is polishing considered reconditioning? - BlackholeZ 21:04:24 04/02/13 Re: Is polishing considered reconditioning? - Tech@EPR 17:28:07 04/03/13 If it needs a grind, just go with a good condition original - ZinnZ32 12:19:03 04/03/13 Not going for big power, want reliable, and smooth - BlackholeZ 04:00:52 04/04/13 looks like it'd be fine after a grind and oversize bearings. (n/m) - nemo1080 (Iowa) 12:47:41 04/03/13 I wouldn't ever grind an OEM crank... - ZinnZ32 13:52:23 04/03/13 Re: I wouldn't ever grind an OEM crank... - Tech@EPR 17:29:44 04/03/13 I think Zinn was meaning not to grind without re-nitriding - ttsmokin 19:59:05 04/03/13 Is it even worth it though to go through all that? - BlackholeZ 04:04:10 04/04/13 +1 Pretty sure getting one Nitrided isn't easy or cheap... (n/m) - ZinnZ32 12:37:47 04/04/13 Re: +1 Pretty sure getting one Nitrided isn't easy or cheap... - Tech@EPR 13:44:39 04/04/13 Looking around it's a couple hundred bucks. (n/m) - BlackholeZ 01:43:50 04/05/13
Post a Followup	You cannot reply to this message because you are not logged in.