Subject	Re: Using a tie rod (I think mini ball joints is a
Posted by	Stryker on March 28, 2013 at 9:47 AM
	This message has been viewed 349 times.
In Reply To	Using a tie rod (I think mini ball joints is a posted by JMartz on March 28, 2013 at 08:03 AM
Message	"Using a tie rod tool at the knuckle", are you talking about this: And is this the outer tie rod "boot":
Follow Ups	Front inner tie rod Q's; and is my outer tie rod ok? - Stryker 15:50:21 03/27/13 Using a tie rod (I think mini ball joints is a - JMartz 08:03:31 03/28/13 Re: Using a tie rod (I think mini ball joints is a - Stryker 09:47:57 03/28/13 The knucle end is the lower picture. The knuckle - JMartz 11:11:12 03/28/13 Re: The knucle end is the lower picture. The knuckle - OverZealous (CT) 09:06:43 03/30/13 AAaaah! Try not replace anything but the dust boot. - OverZealous (CT) 19:00:34 03/28/13 Are you saying that the inner tie rod might be ok!? - Stryker 08:23:37 03/29/13 Re: Are you saying that the inner tie rod might be ok!? - OverZealous (CT) 09:09:27 03/30/13 Re: Re: Are you saying that the inner tie rod might be ok!? - Stryker 01:08:07 03/31/13 Tie Rod Grease & stuff - OverZealous (CT) 02:06:43 03/31/13 Re: Tie Rod Grease & stuff - OverZealous (CT) 02:44:53 03/31/13
Post a Followup	You cannot reply to this message because you are not logged in.