Subject	10mm bit to remove the head studs?
Posted by	nemo1080 (Iowa) on March 27, 2013 at 2:37 PM
	This message has been viewed 100 times.
In Reply To	Definitely bent rod, used a thin rod to compare the height posted by SMAZ (OKC) on March 25, 2013 at 12:20 AM
Message	shouldn't you be using a 12 point socket on the nut at the top of the head studs? or did you mean head bolts??
Follow Ups	How to repair bent rod #6 from fuel hydrolock? - SMAZ (OKC) 00:44:05 03/21/13 How do you know the rod is bent if you havent taken it apart - Woody75 (Denver) 09:45:08 03/21/13 Not positive, but best guess since they pulled 3-4 ounces - SMAZ (OKC) 10:01:32 03/21/13 I'm assuming this is the Z Shane called me on last night. - Woody75 (Denver) 10:55:32 03/21/13 No compression numbers from before, but the noise - SMAZ (OKC) 11:08:53 03/21/13 I agree on the noise. - Woody75 (Denver) 11:13:43 03/21/13 Me too. I mentioned it may have had issue before since it - SMAZ (OKC) 11:45:50 03/21/13 Definitely bent rod, used a thin rod to compare the height - SMAZ (OKC) 00:20:25 03/25/13 10mm bit to remove the head studs? - nemo1080 (Iowa) 14:37:19 03/27/13
Post a Followup	You cannot reply to this message because you are not logged in.