Subject	Agreed...but super high readings are indicative
Posted by	Fly-Surf on March 25, 2013 at 2:37 PM
	This message has been viewed 139 times.
In Reply To	Also, injectors are fairly fussy when putting ohmeters on posted by Red Hawk (CO) on March 25, 2013 at 10:58 AM
Message	of a problem!
Follow Ups	How do I check coil signal and injector signal - Fly-Surf 19:24:41 03/24/13 Why not just ohm the injector. - Woody75 (Denver) 09:20:00 03/25/13 Want to ensure I had not crossed wires... - Fly-Surf 10:02:45 03/25/13 Injectors do not care about polarity (n/m) - ttsmokin 10:52:07 03/25/13 How about coil packs? - Fly-Surf 14:36:04 03/25/13 Also, injectors are fairly fussy when putting ohmeters on - Red Hawk (CO) 10:58:57 03/25/13 Agreed...but super high readings are indicative - Fly-Surf 14:37:14 03/25/13 Exactly. - Red Hawk (CO) 14:44:20 03/25/13 For the injectors - just a simple LED + resistor is needed. - jzack 18:22:33 03/25/13
Post a Followup	You cannot reply to this message because you are not logged in.