Subject	I need to replace the #6 injector (closest to driver)
Posted by	rmb300zxtt on March 24, 2013 at 2:23 PM
	This message has been viewed 151 times.
Message	Have replaced two others w/o removing the plenum by grinding off a corner of the casting on the intake tube to get the screw driver in the head, but the intake on the front side of the #6 injector seems to overhang a lot more. Can it be done on this one too w/o grinding thru. Any suggestions on the right too to take odd 1/4" of aluminum?. I have drills and a Dremel but the Dremel bits look way too light.
Follow Ups	I need to replace the #6 injector (closest to driver) - rmb300zxtt 14:23:08 03/24/13 They all can be done via grinding. - Woody75 (Denver) 23:22:48 03/24/13 Seems to be the one injector with most frequent failures. - JMartz 13:52:02 03/26/13
Post a Followup	You cannot reply to this message because you are not logged in.